Setting Alarm 1, 2 And 3; Upper Limit Of Alarm 1, 2 And 3; Lower Limit Of Alarm 1, 2 And 3 - FE PXR4 Operation Manual

[Description]
• These parameters are used to for settings of alarm 1, 2
and 3.
• When the alarm type (
0 to 15, alarms 1, 2 and 3 (
set.
• When the alarm type (
any value other than 0 to 15, the upper and lower limits
of alarm 1, 2 and 3 (
) can be set.
[Setting example] Setting the operation value of alarm 2 to -10°C
Display
1.
2.
3.
4.
5.
6.
1.800.561.8187
22
Setting alarm
1, 2 and 3
Upper limit of alarm
1, 2 and 3
Lower limit of
alarm 1,2 and 3
or
, ) is set to
and
, ) can be
or
, ) is set to
,
, , ,
Press and hold the key for one second.
SEL
will be displayed on the PV display.
Press the key to display
Press the SEL key once.
The current setting ( ) flashes on the SV display.
Press the or keys to display
Press the SEL key once.
controller will operate with the operation value of alarm 2 being -10°C.
If you want to display the operation status, press and hold the
www.
}
(Setting range:
Absolute value alarm: 0 to 100%FS
Deviation value alarm: -100 to 100%FS )
(Option)
[Note]
Setting codes (12 to 15) cannot be selected in alarm
type 1 and 3 (
Related parameters:
,
Operating procedure
.
.
will stop flashing and will be registered for
.com
/ ).
, , (page 46)
,
, (page 59)
,
, (page 55)
,
, (page 60)
. After that, the
key for two seconds.
SEL
information@itm.com