Cycle Time Of Control Output 2 (Cooling-Side) - FE PXR4 Operation Manual

Cycle time of control output 2 (Cooling-side)

(Setting range: 1 to 150 seconds) (Option: Available for DUAL output only)
[Description]
• By this parameter is set, the cycle time of control output 2.
• While input is within the proportional band, output
changes between ON and OFF in cycles. These cycles
are called cycle time.
Output: ON
Cycle
time
• Do not set this parameter to "0".
[Setting example] Setting the cooling-side cycle time from 30 seconds to 20 seconds
Display
1.
2.
3.
4.
5.
6.
1.800.561.8187
38
Cycle
time
Press and hold the key for three seconds.
SEL
will be displayed on the PV display.
Press the key to display
Press the SEL key once.
The current setting ( ) flashes on the SV display.
Press the or key to display
Press the SEL key once.
controller will operate with the cooling-side cycle time being 20 seconds.
If you want to display the operation status, press and hold the
www.
For contact output:
The higher the frequency of output is, the more precise
the control becomes. However a high frequency of out-
put may shorten the life of the contacts and the device to
be controlled. Be sure to adjust the proportional cycles
considering controllability and the life of the device and
the contacts.
Typical: 30 seconds
Operating procedure
.
.
will stop flashing and will be registered for
.com
. After that, the
SEL key for two seconds.
information@itm.com