Rcj (Cold Junction Compensation) - FE PXR4 Operation Manual

[Description]
• This parameter sets whether or not to perform the RCJ
(Cold junction compensation) for the thermocouple in-
put. Use the factory default setting (ON: performs the
RCJ) under normal conditions.
ON: Performs the RCJ (Cold junction compensation).
OFF: Does not perform the RCJ (Cold junction com-
[Setting example] Changing the RCJ (Cold junction compensation) from ON to OFF
Display
1.800.561.8187
RCJ (Cold junction compensation) (Setting range: ON/OFF)
pensation).
1.
Press and hold the
will be displayed on the PV display.
2.
Press the
3.
Press the
SEL
The current setting (
4.
Press the or
5.
Press the key once.
SEL
controller will operate with the RCJ (Cold junction compensation) being
6.
If you want to display the operation status, press and hold the
www.
• Set this parameter to OFF under the conditions that the
RCJ is not needed, such as when the RCJ is performed
outside of the PXR or when the temperature deviations
are recorded.
Operating procedure
SEL key for five seconds.
key to display .
key once.
) flashes on the SV display.
keys to display
will stop flashing and will be registered for
.com
.
key for two seconds.
SEL
information@itm.com
. After that, the
.
65