Remote Sv Input (0%) Adjustment; Remote Sv Input (100%) Adjustment - FE PXR4 Operation Manual

[Description]
* These parameters are used to correct the deviation of remote SV input.
By setting 0 to the parameters, the status at the time of delivery from the factory can be restored.
1. To correct the deviation from zero point (0% input side)
(1) Enter the value equivalent to 0% to remote SV.
(2) Check that
(3) Enter in
(4) Check on the
2. To correct the deviation of span point (on 100% input side)
(1) Enter the value equivalent to 100% to remote SV.
(2) Check that
(3) Enter in
(4) Check on the
Related parameters:
[Setting example] Setting zero adjustment +1°C
Display
1.800.561.8187
Remote SV input (0%) adjustment (Setting range: -50 to 50% FS) (Option)
Remote SV input (100%) adjustment (Setting range: -50 to 50% FS)
is displayed, and then check the deviation of SV value on the 0% side.
the value to correct the deviation observed in (2).
display that the input has been corrected.
is displayed, and then check the deviation of SV value on the 100% side.
the value to correct the deviation observed in (2).
display that the input has been corrected.
(page 17)
(page 76)
(page 77)
1.
Press and hold the
will be displayed in the PV display section.
2.
Press the key to display
3.
Press the key once.
SEL
The current set value ( ) in the SV section flickers.
4.
Press the and
5.
Press the SEL key once. Flickering stops and
The operation is then performed at zero adjustment
6.
To display the operation status, press and hold the
www.
Operating procedure
SEL key for 5 seconds.
.
keys to display .
.com
= °
1 C is registered.
+ °
1 C.
key for 2 seconds.
SEL
information@itm.com
75