External Peripheral Interface Connection; Figure 4-8: Single Rs-232 Cable Installation - IEI Technology NANO-KBN-i1 User Manual

Figure 4-8: Single RS-232 Cable Installation

S te p 3: Secure the bracket. The single RS-232 connector has two retention screws
that must be secured to a chassis or bracket.
S te p 4: Connect the serial device. Once the single RS-232 connector is connected to
a chassis or bracket, a serial communications device can be connected to the
system.
4.6 Exte rn a l P e rip h e ra l In te rfa c e Co n n e c tio n
The following external peripheral devices can be connected to the external peripheral
interface connectors.

HDMI devices

RJ-45 LAN cable

USB devices

VGA monitors
To install these devices, connect the corresponding cable connector from the actual
device to the corresponding NANO-KBN-i1 external peripheral interface connector making
sure the pins are properly aligned.
P a g e 58
NANO-KBN-i1