Setup Procedure For Linux; Figure B-21: Press Any Key To Continue; B.3 S Etup P Rocedure For L Inux - IEI Technology NANO-KBN-i1 User Manual

NANO-KBN-i1
S te p 12: The recovery tool main menu window is shown as below. Press any key to
reboot the system.

Figure B-21: Press Any Key to Continue

B.3 S e tu p P ro c e d u re fo r Lin u x
The initial setup procedure for Linux system is mostly the same with the procedure for
Microsoft Windows. Please follow the steps below to setup recovery tool for Linux OS.
S te p 1: Hardware and BIOS setup. Refer to Section B.2.1.
Install Linux operating system. Make sure to install GRUB (v0.97 or earlier)
S te p 2:
MBR type and Ext3 partition type. Leave enough space on the hard drive to
create the recover partition later.
NOTE:
If the Linux OS is not installed with GRUB (v0.97 or earlier) and Ext3,
the Symantec Ghost may not function properly.
While installing Linux OS, please create two partitions:

Partition 1: /

Partition 2: SWAP
S t e p 0 :
P a g e 113