Internal Peripheral Device Connections; Audio Kit Installation; Figure 4-5: Lvds Voltage Selection Jumper Location - IEI Technology NANO-KBN-i1 User Manual

NANO-KBN-i1

Figure 4-5: LVDS Voltage Selection Jumper Location

4.5 In te rn a l P e rip h e ra l De vic e Co n n e c tio n s
This section outlines the installation of peripheral devices to the on-board connectors
4.5.1 Au d io Kit In s ta lla tio n
The Audio Kit that came with the NANO-KBN-i1 connects to the audio connector on the
NANO-KBN-i1. The audio kit consists of three audio jacks. Mic-in connects to a
microphone. Line-in provides a stereo line-level input to connect to the output of an audio
device. Line-out, a stereo line-level output, connects to two amplified speakers. To install
the audio kit, please refer to the steps below:
S te p 1: Locate the audio connector. The location of the 10-pin audio connector is
shown in Chapter 3.
Align pin 1. Align pin 1 on the on-board connector with pin 1 on the audio kit
S te p 2:
connector. Pin 1 on the audio kit connector is indicated with a white dot. See
Figure 4-6.
P a g e 55