Single Rs-232 Cable; Figure 4-7: Sata Drive Cable Connection - IEI Technology NANO-KBN-i1 User Manual
Epic sbc s upports amd embedded g-series soc with
vga/hdmi/lvds, dual pcie gbe, usb 3.0, pcie mini, sata 6gb/s , msata, com, iris-1010, hd audio and rohs
Hide thumbs
Also See for NANO-KBN-i1:
- Quick installation manual (17 pages) ,
- Quick installation manual (15 pages) ,
- Quick installation manual (17 pages)
Table of Contents
Advertisement
NANO-KBN-i1
Figure 4-7: SATA Drive Cable Connection
S te p 3:
Connect the cable to the SATA disk. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See Figure 4-7.
To remove the SATA cable from the SATA connector, press the clip on the
S te p 4:
connector at the end of the cable.
4.5.3 S in g le RS -232 Ca ble
The single RS-232 cable consists of one serial port connector attached to a serial
communications cable that is then attached to a D-sub 9 male connector. To install the
single RS-232 cable, please follow the steps below.
S te p 1:
Locate the connector. The location of the RS-232 connector is shown in
Chapter 3.
Insert the cable connector. Insert the connector into the serial port box header.
S te p 2:
See Figure 4-8. A key on the front of the cable connectors ensures the
connector can only be installed in one direction.
S te p 0:
P a g e 57
Advertisement
Table of Contents
