Vision Max Pro User Manual page 49

Operation 49
button will highlight the up arrow in the bottom left corner of the Pendant screen.
Set Surface Button - The set surface button is used to set the surface point of the
material you are engraving. The procedure for setting the surface is as follows:
a) Use the X & Y jog buttons to move the spindle over the material to be engraved.
b) Press the Set Surface button. The Pendant screen will display the message below
c) Lower the spindle with the Z down jog button until you reach the desired position.
d) Press the Enter button to set this as the surface position. The spindle will then move up to its lift
position.
HINT: It is sometimes easier to set the surface right before engraving the job. To do this, send a job to
the machine to be engraved. Press Pause. Press Start. The spindle will move to the first point to be
engraved and pause. You can then jog the Z down until you reach the desired Z position, then press Set
Surface, then press Enter to set the surface. Pressing Start will then begin the engraving process..
, then
Shift, then Set Surface Button - When you first press the Shift
button, then press the Set Surface button, the red dot laser pointer will power on. Repeating Shift, then
Set Surface will turn the red dot laser point off.
© 2015 Vision Engraving Systems