Vision Max Pro User Manual page 50

50 Vision Max Pro User Manual
Goto Home Button - When you press the Goto Home button, the engraver will return to
its home position, which is either the default location in the upper left corner of the T-slot table, or a user
defined home position. Pressing this while a job is running will lift the spindle up, move to the home
position and cancel the job from the machine.
IMPORTANT: When the machine is first powered on, the Goto Home button must be pressed in order to
set the home position of the machine before running any jobs.
, then
then press the Goto Home button, the engraver will return to the top left corner of the T-Slot table and
"re-home". This is used if the machine has lost position for some reason.
Set Home Button - The Set Home button is used to set a user defined home position. To
define a home position, use the X & Y jog buttons to move the spindle to a point you want to set as the
home position. Press the Set Home button. The message "Home Set." will briefly appear on the Pendant
screen. This position is now set as the home (0,0) position. To reset this home back to the machine's
home position at the upper left corner of the T-Slot table, press Shift, then press Goto Home, then press
the Set Home button.
Setting a Home Using the Red Dot Laser Pointer - The red dot laser pointer can be used to set the
machine's home position. Turn on the red dot laser pointer by pressing the Shift button, the pressing the
Set Surface button. Jog the motion system to the desired location using the X & Y jog buttons and the
red dot laser pointer for positioning. Press Set Home to save the home position in the machine. If you
want to save a new home position, move the spindle to the desired position and press Set Home as
described above.
, then
replaced with the factory home position. To reset the machine to the user defined home position, Press
Shift, then Set Home. The machine will now use the user defined home position.
Goto Limits Button - The Goto Limits button is used to send the motion system to its
upper left corner limits. This button is typically used for troubleshooting purposes only.
Shift, then Goto Home Button - When you press the Shift button,
- If the machine is turned off, the user defined home position will be
© 2015 Vision Engraving Systems