Vision Max Pro User Manual page 67

Operation 67
The dimensions of the plate size shown in the Plate Size window will now reflect the engraving area you
have defined on the machine. The Home Position of the machine has also been set to the upper left
corner of this area.
The machine will also allow you to outline the engraving area you just defined. Follow the instructions on
your machine or controller to have the machine outline this engraving area with the red dot laser pointer.
If the area appears to be correct. click on OK in the Plate Size window. The plate size in the Vision 9
software now shows the area defined with the measure feature. Design your job and send the job to the
engraver.
Note that when using the measure feature, the machine will have its home position changed. You will
need to reset the home position to the upper left hand corner of the engraving table in order to use the
machine normally.
© 2015 Vision Engraving Systems