Vision Max Pro User Manual page 140

140 Vision Max Pro User Manual
In this example, the item has a handle. The normal orientation for items with a handle it to place the
graphics 90 degrees to the right of the handle, unless both sides are to be engraved.
Using the Pendant, press the Rotary Axis Key and select 1, which enables the rotary axis and moves the
spindle over the centerline of the rotary vise. Enter the diameter of the item using the numbers on the
Pendant's key pad, then press Enter on the Pendant.
The design of the vise allows the user to tilt it in order to position the item to be engraved so that the area
to be engraved is as level as possible to the X-Axis of the carriage and perpendicular to the spindle axis.
If needed, loosen the lever under the vise and tilt it so that the item is angled properly and perpendicular
to the spindle axis. In this example, the item did not require to have the rotary axis tilted.
© 2015 Vision Engraving Systems