Vision Max Pro User Manual page 48

48 Vision Max Pro User Manual
position of the spindle on the T-Slot table work area. This is used to position graphics, or to locate an
area for engraving. The X jog buttons will move the spindle left and right. The Y jog buttons will move the
spindle front to back. As you use the X & Y jog buttons, the Jog speed will determine how fast the
spindle will move and the spindle position will be displayed on the Pendant screen as highlighted below.
Z Jog Buttons - These will move the spindle up and down. These buttons are commonly
used for setting the surface of your material when you are not using the proximity sensor. The spindle
will jog up and down at the Jog speed displayed on the Pendant screen (medium, slow or fast). As you
use the Z jog buttons, the spindle position will be displayed on the Pendant screen as shown above.
Shift button - The Shift button is used to access different functions. Pressing the Shift
X & Y Jog Buttons - The X & Y jog buttons are used to move the
© 2015 Vision Engraving Systems