Vision Max Pro User Manual page 51

Prox sensor enables the machine to determine the Z position of the material. This feature works when
engraving with a nose cone or diamond drag only; it is not designed for non-nose cone engraving or
burnishing. The Pendant screen displays the status of the proximity sensor as (Auto) or Off.
Note: The proximity sensor can be turned on or off from within the Vision Pro software. When the
Engrave icon is selected, the proximity icon can be selected or deselected to automatically turn the
proximity sensor on or off when the job is running.
Proximity sensor on icon:
Proximity sensor off icon:
can toggle between these two modes by pressing the Spindle On/Off button. When set to (Auto), the
spindle will automatically turn on and off at the beginning and end of the engraving job. If you press the
PAUSE or STOP button, the spindle will turn off for safety reasons. Always make sure you have the
spindle turned on when appropriate, otherwise you may run the risk of breaking your cutter. When
pressing the Spindle On/Off button, the Pendant screen will display the status as (Auto), or Off.
Note: The spindle can be changed to on or off from within the Vision Pro software. When the Engrave
icon is selected, the spindle icon can be selected or deselected to automatically turn the spindle on or
off when the job is running.
Spindle on icon:
Spindle off icon:
© 2015 Vision Engraving Systems
Prox On/Off Button - This button allows you to turn the Proximity Sensor on and off. The
Spindle On/Off Button - The spindle motor can be either in automatic mode or off. You
Operation 51