Vision Max Pro User Manual page 61

Operation 61
or Off. The Vision Pro software automatically turns this function on or off with the job. This function is
used only when the machine is being run from software other than Vision Pro.
Inserter Offset - Pressing Enter with this item highlighted will allow the user to modify the factory set
offset used with the Braille Inserter tool. The offset is from the spindle centerline to the Braille Inserter
centerline. The X and Y offsets are set for each machine if the Braille Inserter option was ordered from
the factory. If the user restores factory defaults, the X and Y offsets will need to be reset. To modify the
offsets, highlight the menu item and press Enter. Using the numeric buttons, enter the desired X offset,
then press Enter. Enter the Y offset using the numeric buttons, then press Enter. Enter the Z-lift setting
with the numeric buttons, then press Enter to save these settings. To return to the main Pendant screen,
press the Exit button two times.
Run Self Test - Pressing Enter with this item highlighted will allow the user to engrave a self test job that
is programmed into the controller. Move the cursor to the Run Self Test menu item using the Y up and
down jog buttons and press Enter. The Pendant screen will display "Run Self-Test". Use the Y up or
down buttons to select Yes or No, then press Enter. The Pendant screen will now show "Press Start to
Go". Press the Start button to begin engraving the test job.
Auto Braille - Pressing Enter with this item highlighted will allow the controller to turn the automatic
braille detection On or Off. A reboot will be required to retain this setting. If using the Vision Pro
software, this setting is normally left as On. If the user sends files from another software program, turn
this feature off and using the Braille Insterer feature described above, turn On the Braille Inserter
feature.
© 2015 Vision Engraving Systems