Vision Max Pro User Manual page 46

46 Vision Max Pro User Manual
If a job has been sent to the machine and has been run, the Start button has another feature. If you are
using the Connectivity Manager (not Machine Tools), pressing the Start button after the job has been
run, will recall the job. Pressing the Start button once more will run the same job.
, then
Shift, then Start Button
When connected via Connectivity Manager - Pressing Shift, then Start with a job in the machine will
perform a dry run of the job with the red pointer on the machine. The red pointer will outline the job to be
engraved. If there is no job in the machine, this function will attempt to connect to your computer and
you will receive the messages "Connecting to host...", then, "Host not responding!" This is normal, as
this button combination is not meant to be used with the connectivity manager.
When connected to Vision Machine Tools - If there is no job in the machine, pressing Shift, then Start
will display a list of jobs that are stored on the computer's hard drive. Use the Y up and down jog buttons
to move the cursor on the Pendant screen to the job to be engraved and then press Enter to select the
job. Pressing Start will run the job. If a job is in the machine and ready to be engraved, pressing Shift,
then Start will perform a dry run of the job with the red pointer on the machine. The red pointer will
outline the job to be engraved.
Pause Button - The Pause button is used to momentarily stop the machine from
engraving. If you press the Pause button while the machine is engraving, the machine will lift the cutter
up from the material and stop engraving. The spindle motor and vacuum will power off while in Pause
mode. Pressing the Start (or Enter) button will resume (Continue) the engraving where it left off. To
Cancel the job, use the Y Up or Down buttons to select Cancel, then press the Enter button. When in
Pause mode, the Pendant screen will display:
© 2015 Vision Engraving Systems