Activating Or Deactivating Alerts; Deleting Alerts - HP 316095-B21 Installation Manual

If the alert is active, an error message is displayed prompting you to deactivate the alert.
3. If the alert is active, click Deactivate, and then select the alert information in the table again.
4. Click Modify.
An initial Modify Threshold screen that allows the you to change the threshold type is displayed.
5. Select a threshold type from the drop-down list.
6. Click Next when you are done.
A Modify Threshold screen is displayed. This screen allows you to change the % utilization,
cumulative minutes for the threshold to occur before notification, and the time interval for
measuring throughput and for alert notification.
7. Make the appropriate changes, and then continue through the Modify Threshold screens,
making changes as necessary, until the summary screen is displayed in the alert configuration.
Perform either of the following steps:
8.
• If you need to change any parameters, click Previous or Next to display the desired Modify
Threshold screen.
• Click Finish when you are done.

Activating or deactivating alerts

Use the following steps to activate or deactivate existing threshold alerts:
NOTE: In the active state, notifications are generated for the alert. In the inactive state, notifications
do not occur.
1. At the Hardware view, select Configure > Threshold Alerts.
The Configure Threshold Alerts dialog box is displayed.
The port's current state, inactive or active, is listed in the State column.
2. To change the state, select the alert by the alert information in the table.
3. If the alert is active, select Deactivate to change to the inactive state. If the alert is inactive, select
Activate to change to the active state.

Deleting alerts

Use the following steps to delete existing threshold alerts:
1. At the Hardware view, select Configure > Threshold Alerts.
The Configure Threshold Alerts dialog box is displayed.
2. Select the alert that you want to delete by selecting the alert information in the table, and click
Delete.
A message is displayed asking you to confirm the deletion.
3. Click Yes.
The alert is removed from the dialog box.
68 Using HAFM to configure the Edge Switch