Configure And Enable Call-Home Features; Configure And Enable Ethernet Events - HP storageworks 2/32 Installation Manual

Installing and Configuring the Edge Switch 2/32
4. Click the switch icon. The Hardware View page for the selected switch
5. At the Hardware View page for the selected switch, choose Maintenance >

Configure and Enable Call-Home Features

There are two call-home features available, and only one is installed when the
HAFM application is installed on the HAFM server. To learn more about
configuring Call-Home features, refer to the appropriate HAFM Server
Installation Guide.

Configure and Enable Ethernet Events

Perform this procedure to configure and enable Ethernet events. An Ethernet event
is recorded (after a user-specified time interval) when the director-to-HAFM
Server communication link drops. To configure and enable Ethernet events:
1. Choose Maintenance > Configure Ethernet Events. The Configure
Figure 23: Configure Ethernet Events dialog box
2. Click the Enable Ethernet Events check box. A check mark displays in the
3. Type a value from 10 through 120 minutes in the Ethernet Timeout field.
4. Click OK to close the dialog box.
70
displays.
Enable E-Mail Notification. A check mark displays in the check box to
indicate e-mail notification for the switch is enabled, and the menu closes.
Ethernet Events dialog box displays, as shown in
check box to indicate Ethernet events are enabled.
Figure 23.
Edge Switch 2/32 Installation Guide