Configuring Snmp Trap Message Recipients - HP 316095-B21 Installation Manual

3. Click OK to save the information.
An acknowledgement message is displayed, indicating the browser PC must be directed to the
new IP address.
Update the address resolution protocol (ARP) table for the browser PC:
4.
a. Select File > Close to close the HAFM Basic and browser applications.
The Windows desktop is displayed.
b. Select Start > Programs > Command Prompt.
A disk operating system (DOS) window is displayed.
c. Delete the Edge Switch's old IP address from the ARP table as follows:
At the command (C:\) prompt, enter arp —d xxx.xxx.xxx.xxx, where
xxx.xxx.xxx.xxx is the old IP address for the Edge Switch.
d. Click close (X) at the upper right corner of the DOS window to close the window and return
to the Windows desktop.
Press and hold the IML/RESET button on the product front panel for ten seconds to perform a
5.
power-on reset (POR).
Launch the browser application on the PC (Netscape Navigator or Internet Explorer).
6.
7. Enter the Edge Switch's new IP address as the Internet URL in the browser.
The Enter Network Password dialog box is displayed.
8. Enter the default user name and password.
NOTE:
The user name and password are case-sensitive.
9. Click OK.
The HAFM Basic interface opens with the View window displayed.

Configuring SNMP trap message recipients

Perform this procedure to configure community names, write authorizations, and network addresses
for up to 6 SNMP trap message recipients per Edge Switch. A trap recipient is a management
workstation that receives notification (through SNMP) if a switch event occurs.
1. Select Configure > SNMP.
The default user name is Administrator and the default password is password.
Edge Switch 2/32 installation guide 87