Configuring Network Information; Network View - HP 316095-B21 Installation Manual

The following message is displayed:
Your changes have been successfully activated
5. Set the Edge Switch online (see

Configuring network information

The way in which you configure network information depends on the type of LAN installed at your
facility:
• If one Edge Switch is installed on a dedicated LAN, network information (IP address, subnet
mask, and gateway address) does not require change. Go to
on page 77.
• If multiple Edge Switches are installed or a public LAN segment is used, network information
must be changed to conform to your LAN addressing scheme. Perform one of the following:
• If network information was changed while
page 35, go to
• If network information was not changed, perform the procedure that follows.
To change an Edge Switch IP address, subnet mask, or gateway address:
1. Select Configure > Switch > Network.
The Network view is displayed
Figure 51

Network view

2. Make the following entries:
a. Enter the new value specified by the network administrator in the IP Address box.
Default is 10.1.1.10.
b. Enter the new value specified by the network administrator in the Subnet Mask box.
Default is 255.0.0.0.
c. Enter the new value specified by the network administrator in the Gateway Address box.
Default is 0.0.0.0.
86 Using the HAFM Basic interface
"Setting the Edge Switch offline and
"Configuring SNMP trap message
(Figure 51).
"Configuring Edge Switch
performing"Edge Switch network
recipients" on page 87.
online" on page 77).
ports"
addresses" on