Configuring Ports - HP 316095-B21 Installation Manual

The Configure Preferred Paths dialog box is displayed
Figure 23 Configure Preferred Paths dialog box
Click Add.
2.
The Add Preferred Path dialog box is displayed
Figure 24 Add Preferred Path dialog box
3. At the Source Port box, enter a value from 0 through 31.
For this Edge Switch, the value uniquely identifies the starting port for the preferred path.
4. At the Exit Port box, enter a value from 0 through 31.
For this Edge Switch, the value uniquely identifies the exit port for the preferred path.
5. At the Destination Domain ID box, enter a value from 1 through 31.
This value uniquely identifies the destination Director or Edge Switch in the path.
6. Click OK to close the Add Preferred Path dialog box and add the path to the list in the Configure
Preferred Paths dialog box.
7. Repeat step 2
8. At the Configure Preferred Paths dialog box, select the Enable Preferred Path check box.
9. Click Activate to enable all configured preferred paths and close the dialog box.

Configuring ports

Perform this procedure to define Fibre Channel port names, configure ports as blocked or
unblocked, enable extended distance operation and link incident (LIN) alerts, configure port
binding, and define port types.
1. At the Hardware view for the selected Edge Switch, select Configure > Ports.
56 Using HAFM to configure the Edge Switch
through step 6 to configure additional preferred paths.
(Figure 23).
(Figure 24).