Mounting The Slide Rails On The Sides Of The Edge Switch; Assembling The Rack Mount Kit Hardware (Rear-To-Front) - HP 316095-B21 Installation Manual
Edge switch 2/32
Hide thumbs
Also See for 316095-B21:
- Service manual (322 pages) ,
- User manual (300 pages) ,
- Reference manual (214 pages)
Table of Contents
Advertisement
6.
Secure, but do not completely tighten, all screws.
Figure 6
Assembling the rack mount kit hardware (rear-to-front)
Mounting the slide rails on the sides of the Edge Switch
Tools and equipment required:
•
Ten (10) #6 x 3/8 inch flathead screws.
•
Fixed-length slide rails.
•
Torx tool.
•
The appropriate size ear brackets for the rack. (The longer ear brackets are used for the HP
9000 and 11000 series racks. All other racks use the shorter ear brackets.)
NOTE:
You may want to remove the Edge Switch power supplies, as this will make the device
lighter and easier to handle.
WARNING!
service manual for details on removing power supplies.
1.
Position the two slide rails and ear brackets at the rear of the switch, on either side, as shown in
Figure
7.
28
Installing the Edge Switch
Before removing the power supplies, review the HP StorageWorks Edge Switch 2/32
Advertisement
Table of Contents
