Figure 46
Rx BB credit view
3.
Click Default to select the default values.
A confirmation message is displayed.
4.
Click OK to accept the default values.
NOTE:
enter values in the RX BB Credit box.
NOTE:
then click go.
5.
Click OK to save the changes.
6.
Place the port back online (see
Configuring Edge Switch identification
Perform this procedure to configure the Edge Switch name, description, location, and contact
person. The Name, Location, and Contact variables configured here correspond respectively to
the SNMP variables sysName, sysLocation, and sysContact. These variables are used by
SNMP management workstations when obtaining data from managed switches.
To configure the Edge Switch identification:
80
Using the HAFM Basic interface
HP recommends that you use the default values. If they are not appropriate, you can
If you want to select another port, enter the port number in the Jump to Port box and
"Setting the Edge Switch offline and
online" on page 77).