Chapter 5
Component Removal/Installation
5.17 Main Power
Switch
Bottom enclosure
5-26
Follow these steps to remove the main power switch (Figure 5-27). Reverse to
install.
1. Remove the blower (section 5.12).
2. Disconnect the main power switch cable from its connector on the
power supply subsystem (PSS J7).
3. Pull the switch away from the back panel, feeding its cable through
the back panel cutout.
Main power switch
cable (PSS J7)
Power supply
subsystem (PSS)
Figure 5-25: Removing the Main Power Switch
BiPAP Vision Service Manual © Respironics, Inc.
Back panel
Main power switch
1062788