How to Configure SAS / SATA Raid
IMPORTANT
This chapter describes how to configure the disk controller card. This software configuration is
specific only to vendor Areca. Different vendors (i.e. ATTO, Intel, LSI and etc.) of disk controller
cards have their own software utility for RAID configuration and management. If you are using a
non-Areca card make sure to check with the vendor or manufacturer of the card for further
instructions.
Areca has its own Graphical User Interface for RAID configuration and management.
follow the instructions below
1.
Go to
http://www.areca.com.tw
2.
Click Support & Downloads
3.
Go to Driver / Utility, select Windows
4.
Under "Windows-ArcHTTP" click, Version V2.3.4 to download
5.
Save File "winhttp_V2.3.4_130325.zip"
6.
Extract the File
7.
Click Install.exe to install Archttp
8.
After Installation, reboot Computer
NOTE: These steps are applicable to Windows 7, Windows 8 and Mac OSx. Use Firefox / Mozilla as
your Browser to launch the ARCHTTP.
Roben 3 | Chapter 3
Magma
You need to install Archttp first,
Verify Installation
74