Open Enclosure; Install Thunderbolt Interface Card; Install Pcie Cards - Magma ROBEN Series User Manual

Open Enclosure

Loosen the thumbscrew that retains the top cover of the chassis and slide the lid towards you as shown below:

Install Thunderbolt Interface card

The thunderbolt Interface card is already installed for this model. No need to install the Thunderbolt Interface card
If you need to replace or install a Thunderbolt Interface card, go to Thunderbolt Interface card Installation on
page 26. If you bought an expansion 3slot chassis with an Ipass interface card you have to remove it first prior to
installing the Thunderbolt Interface card.

Install PCIe Cards

Some card manufacturers recommend that you install their software driver prior to installing the card. If this is the
case, be sure to install the card driver before connecting Roben-3to the computer.
• Slot 3 accepts all types of PCIe cards x1, x2, x4, x8 or x16
• Slot 2 accepts all types of PCIe cards x1, x2, x4, x8 or x16
• Slot 1 accepts all types of PCIe cards x1, x2, x4, x8 or x16 (next to Thunderbolt interface card)
Roben 3 | Chapter 2 Hardware Installation
Magma
13