Oracle SPARC T7-1 Installation Manual page 75

5. In the left navigation panel, click on Host Management → Power Control.
Select Reset from the pull-down menu, and click Save.
6.
In the left navigation panel, click on Remote Control → Redirection.
7.
Select Use Serial Redirection, and click Launch Remote Console.
8.
As the host resets, messages are displayed in the serial console. The reset activity takes a few
minutes to complete. When the ok prompt is displayed, continue to the next step.
9.
At the ok prompt, boot from the appropriate boot media for your installation
method.
For more information, refer to the Installing Oracle Solaris 11 Systems, comparing installation
options at:
http://www.oracle.com/goto/solaris11/docs
For a list of valid boot commands that you can enter at the OpenBoot prompt, type:
{0} ok help boot
boot <specifier> ( -- )
Examples:
boot
boot net
boot cdrom
boot disk1:h
boot tape
boot disk myunix -as
dload <filename> ( addr -- )
Examples:
4000 dload /export/root/foo/test
?go - if executable program, execute it
10. During the installation, supply the configuration parameters as directed.
See "Oracle Solaris OS Configuration Parameters" on page
Related Information
"Configure the Preinstalled OS" on page 71
■
"Reach a State to Install a Fresh OS (Oracle ILOM CLI)" on page 72
■
"Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)" on page 74
■
"Assign a Static IP Address to the NET MGT Port" on page 77
■
Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)
boot kernel ( default ) or other file
- boot kernel from default device.
Factory default is to boot
from DISK if present, otherwise from NET.
- boot kernel from network
- boot kernel from CD-ROM
- boot from disk1 partition h
- boot default file from tape
- boot myunix from disk with flags "-as"
debug load of file over network at address
or if Forth program, compile it
76.
Powering On the Server for the First Time 75