Table of Contents
Advertisement
Rack Compatibility
not ordered with the server are shipped separately. If possible, install these components prior to
installing the server in a rack.
Except for the rackmount kits, if you ordered any options that are not factory-installed, refer
to the service manual for the server and the component's documentation for installation
instructions.
Note -
pages for the most current list of components supported in the server.
Related Information
Optional component documentation
■
SPARC T7-1 Server Service Manual
■
Rack Compatibility
Check that your rack is compatible with the slide rail and CMA options. The optional slide rails
are compatible with a wide range of equipment racks that meet the following standards.
Item
Structure
Rack horizontal opening and unit vertical pitch
Rack rail mounting hole sizes
Distance between front and rear mounting
planes
Clearance depth in front of front mounting
plane
Clearance depth behind front mounting plane
Clearance width between front and rear
mounting planes
Server dimensions
26
SPARC T7-1 Server Installation Guide • October 2015
The list of optional components can be updated without notice. Refer to the product web
Requirement
4-post rack (mounting at both front and rear). 2-post racks are not
compatible.
Conforms to ANSI/EIA 310-D-1992 or IEC 60927 standards.
Only 9.5-mm square hole and M6 round mounting holes are
supported. All other sizes, including 7.2-mm, M5, or 10-32
mounting holes, are not supported.
Minimum: 24.5 in. (622 mm).
Maximum: 35.25 in. (895 mm).
Distance to front cabinet door is at least 1.06 in. (27 mm).
Distance to rear cabinet door is at least 35.5 in. (900 mm) with the
CMA, or 30.4 in. (770 mm) without the CMA.
Distance between structural supports and cable troughs is at least
18 in. (456 mm).
Depth: 29.0 in. (737 mm).
Width: 17.5 in. (445 mm).
Advertisement
Table of Contents
