Redirecting The Host Console Using Oracle Ilom - Oracle X8-8 Installation Manual

Redirecting the Host Console Using Oracle ILOM

b.

Redirecting the Host Console Using Oracle ILOM

Use Oracle ILOM Remote System Console Plus to remotely redirect a host server desktop or a
host server storage device.
Connecting to the host console through Oracle ILOM enables you to perform actions as if you
were at the host. Connect to the host to perform the following tasks:
Access the server BIOS Setup Utility remotely
■
Install an operating system on the server
■
Configure an operating system on the server
■
Configure or install other software on the server
■
Oracle ILOM Remote System Console Plus supports a full-control console video session for
a primary user and view-only console video sessions for all other signed-in users. By default,
a maximum of four video redirection sessions can be launched from the Oracle ILOM web
interface. To prevent other signed-in video session users on the SP from viewing confidential
data, you can set the Maximum Client Session Count property to 1 on the KVMS page in the
Oracle ILOM web interface.
82 Oracle Server X8-8 Installation Guide • June 2019
Properties:
ping = (Cannot show property)
ping6 = (Cannot show property)
Commands:
cd
set
show
Use the set ping or ping6 command to send a network test from the
device to a network destination specified in the following table.
Property Set Property Value
ping set
ping=<IPv4_address>
ping set
ping6=<IPv6_address>
Description
Type the set ping=command at the command prompt followed
by the IPv4 test destination IPv4 address. For example:-> set
ping=192.168.10.106
Ping of 192.168.10.106 succeeded
Type the set ping6=command at the command prompt followed
by the IPv6 test destination IPv6 address. For example:-> set
ping6=2001::db8:5dff:febe:5000
Ping of 2001::db8:5dff:febe:5000 succeed