Before Using Scan To Shared Folder
Creating a Shared Folder in a Computer
Registering a Destination (Profile)
Registering a Destination (Profile) from Configuration Tool
Registering a Destination (Profile) from the Web Page
Registering a Destination (Profile) from the Operator Panel
Creating a Shared Folder in a Computer
Create a shared folder in a computer in which the scanned document is saved.
1.
Click [Start] on the Windows task bar, right-click [Computer], and
then click [Properties].
2.
Check the name of [Computer name].
You need the computer name you checked when you register the destination in the
machine. Write it down.
3.
Close the window.
4.
Create a folder in which documents are saved on the computer.
5.
Right-click the created folder, and then click [Properties].
6.
Click the [Sharing] tab, and then click [Advanced Sharing].
7.
Select the [Share this folder] check box, and then click
[Permissions].
8.
Select the [Allow] check box of [Change] in [Permissions for
Everyone], and then click [OK].
9.
Click [OK].
Registering a Destination (Profile)
Register the created shared folder in the machine so that the folder can be used for Scan To
Shared Folder.
When you perform Scan To Shared Folder, you send data to the profile that you specify as a
destination.
You can register up to 50 profiles.
You can register a destination (profile) in the following three ways. This manual
recommends to use Configuration Tool or the Web page where you can enter information
233