Baldor MicroFlex e100 Installation Manual page 146

Keyword
DECELTIMEMAX
DRIVEBUSNOMINALVOLTS
DRIVEBUSOVERVOLTS
DRIVEBUSUNDERVOLTS
DRIVEBUSVOLTS
DRIVEENABLE
DRIVEENABLEINPUTMODE
DRIVEENABLEOUTPUT
DRIVEENABLEREADY
DRIVEENABLESWITCH
DRIVEID
DRIVEOVERLOADAREA
DRIVEOVERLOADMODE
DRIVEPEAKCURRENT
DRIVEPEAKDURATION
DRIVERATEDCURRENT
DRIVESPEEDFATAL
DRIVESPEEDMAX
EFFORT
ENCODER
ENCODERCYCLESIZE
ENCODERMODE
ENCODEROFFSET
ENCODERPRESCALE
ENCODERRESOLUTION
C-4 Mint Keyword Summary
Description
To define the deceleration rate of an axis.
To return the nominal value of the DC bus voltage for the
drive.
To set or return the overvoltage trip level for the drive.
To set or return the undervoltage trip level for the drive.
To return the current level of the DC bus.
To enable or disable the drive for the specified axis.
To control the action taken in the event of the drive being
disabled from the drive enable input.
To specify an output as a drive enable.
To read if the drive is ready to be enabled.
To read the state of the drive enable input.
To define a text description for the drive.
Reads the extent of a drive overload condition.
Sets or reads the action taken in the event of a drive
overload condition.
Reads the peak current rating of the drive.
Reads the duration for which peak drive current can be
sustained.
Reads the continuous current rating for the drive.
To define the overspeed trip level.
To set or read the maximum motor speed to be used.
To read the instantaneous effort applied by the current
controllers.
To set or read the axis encoder value.
To set or read the size of a sin/cos cycle on an encoder.
To make miscellaneous changes to the encoders.
To set or read the offset used to calculate encoder
position for absolute encoders.
To scale down the encoder input.
To set or read the number of encoder lines
(pre-quadrature) for the motor.
www.baldormotion.com
MN1943