Configuring The Internal Interfaces - HP 9000 300 Series Service Handbook

Configuring lhe Internal Interfaces
Press [)to configure the internal I/0 interfaces.
If you see error messages, refer to the section in this chapter titled
'Configuration Error Messages.'
The Configurable Interface Menu replaces the Configuration Control Menu and
looks similar to the following.
Configurable Interfaces
Keys Interface Select Code
1
LAN
21
2 SCSI 14
3 HP
Parallel
12
4
RS-232 9
S HP-IB
N
store
New
values
D store Default values
(then cycle SPU power)
A
Abort without changes
Type [key] RETURN
?
The order that interface identifiers appear and their respective number keys
may be different on your controller. Only interfaces that are configurable from
the Boot ROM's Configuration Control Mode will be listed. The Select Code
currently assigned to the interfaces is shown in the column marked "Select
Code".
• To change the configuration of an internal face, first press the appropriate
identifying number. In our example, press [) for LAN,
0
for SCSI,
0
for HP Parallel,
0
for RS-232, and® for HP-IB. Don't forget to press
(Return)/(ENTER)
to complete the command. For the HP-IB, there is no select
code nor interrupt level, so the only change can be to make the internal
HP-IB the System Controller.
• Make the appropriate changes on the interface menu presented.
• To store the new values, press
@.
3-6 ConfigLrations