Update Via The Lan Port - SATO WS408DT Technical Manual

5 Update Firmware
firmware update log.
Sometimes you'll find LED 2 keeps turning to red and orange alternatively
after the message "Done" appears. It means your printer is updating the other
copy of firmware. There are two copies of firmware stored in your printer: master
and backup. They are used to restore each other in case the firmware is lost or
corrupted. By default, the master is the primary copy. Your printer uses the
backup if the master doesn't work.

5.1.2 Update via the LAN Port

Before you update the firmware via the LAN port, you need to set up a network
connection. For details, see
up WLAN connection.
1. Make sure the print module is closed.
2. Turn on your printer, and start SATO WS4 Printer Utility.
3. In the Input/Output Port list, click LAN, and do one of the following:
If you are using the LAN port, the Port Name and Port Information will show
●
the LAN settings after you set up a network connection.
LAN
Update Firmware in SATO WS4 Printer Utility
Set up LAN connection,
88
Set up IPv6 connection and Set