SATO WS408DT Technical Manual page 38

3 System Mode
53. Reflective Sensor Offset
For developers to debug.
54. See-Through Sensor Offset
For developers to debug.
55-63. Font Image
You can use them as the reference to check your label font.
64-69. TPH Test Pattern
You can use them to check broken pins on the printhead.
If your printer has a Wireless LAN module, your SZPL configuration label will
contain the following entries:
1. Interface
It detects if your printer connects to a network. When it's online, it shows "UP";
when it's offline, it shows "DOWN."
2. DHCP
When DHCP is enabled, it assigns an IP address to your printer automatically.
3. IP Address
The IP address of your printer. When DHCP is enabled, it shows the automatically
assigned IP address; when DHCP is disabled, it shows the manually specified IP
address.
4. Netmask
The netmask of your printer. When DHCP is enabled, it shows the automatically
assigned netmask; when DHCP is disabled, it shows the manually specified
netmask.
5. Gateway
The gateway of your printer. When DHCP is enabled, it shows the automatically
assigned gateway; when DHCP is disabled, it shows the manually specified
gateway.
6. SSID
35
Self-Test and Dump
mode
WS4-DT-r01-30-12-16TM