SATO WS408DT Technical Manual page 31

3 System Mode
34. SNMP
When it is enabled, the host gets or sets parameters registered as SNMP entities.
35. Socket Communication
When it is enabled, the host communicates with your printer via the socket.
36. Socket Port
The socket number of your printer.
37. IPv6 Mode
It determines how you get the IPv6 address of your printer. There are three modes:
MANUAL, DHCPv6 or AUTO.
38. IPv6 Type
It is the IPv6 address type of your printer. There are four types: NONE, NORMAL,
EUI and ANY.
39. IPv6 Address
The static IPv6 address of your printer.
40. Link Local Address
The IPv6 address that used in a network segment. It is allocated automatically.
41. Product SN
The serial number of product.
42. USB SN
The Serial number of USB host.
43. TPH and Cutter Offset
For developers to debug.
44. Reflective Sensor Gap Calibration
For developers to debug.
45. See-Through Sensor Gap Calibration
For developers to debug.
46. Reflective Sensor Profile
For developers to debug.
47. See-Through Sensor Profile
For developers to debug.
48. Reflective Sensor Offset
For developers to debug.
49. See-Through Sensor Offset
For developers to debug.
50-55. TPH Test Pattern
You can use them to check broken pins on the printhead.
28
Self-Test and Dump
mode
WS4-DT-r01-30-12-16TM