SATO WS408DT Technical Manual page 59

4 SATO WS4 Printer Utility
Property Name
Reprint After Error
Print Darkness
Print Speed
Unit(Label)
Width
Height
Unit(Position
Adjustment)
Horizontal Offset
Vertical Offset
Tear Off Offset
Cutter Offset
Description
media using a media sensor every time you close the print
module when the printer is turned on.
ON (Power on and Head close)
automatically calibrates media using a media sensor after
power on and every time you close the print module when
the printer is turned on.
OFF You need to manually calibrate media using a media
sensor as you change the media, or your printer won't
work properly.
Enable Your printer when caused by the error condition.
The label is reprinted as soon as the error condition is
corrected.
Disable Disable the reprint after error.
Adjust the darkness relative to the current darkness
setting. The range is 0 ~ +30, and the value is adjustable in
increments of 1.
±
Determine the media speed during printing. The range is
+2 ~ +6, and the value is adjustable in increments of
mm Change the unit of label to millimeter.
inch Change the unit of label to inch.
Set the print width.
Set the length of the label when using continuous media.
mm Change the unit of Position Adjustment to
millimeter.
Inch Change the unit of Position Adjustment to inch.
dots Change the unit of Position Adjustment to dots.
Move the print position horizontally. The positive number
is left, and the negative number is right.
Move the print position vertically. The positive number is
forward, and the negative number is backward.
Adjust the rest position of the media after a label is
printed, which changes the position at which the label is
torn or cut.
Adjust the cutter offset position at which the label is peel
or cut.
55
Work with SATO WS4 Printer Utility
Your printer
1 ips.
±