SATO WS408DT Technical Manual page 35

3 System Mode
1. Version Information
The firmware version and its build date.
2. Standard RAM
Total SDRAM size.
3. Available RAM
RAM is able to be used.
4. Flash Type
The flash memory type and size.
5. Available Flash
Flash is able to be used.
6. No of DL soft fonts (FLASH)
The number of fonts is downloaded in Flash.
7. No of DL soft fonts (RAM)
The number of fonts is downloaded in RAM.
8. No of DL soft fonts (HOST)
The number of fonts is downloaded in USB HOST.
9. H. Position Adjust
Move the print position horizontally.
10. Sensor Type
The media sensor type. It is Gap(transmissive) or I-Mark(reflective) sensor.
11. Label-less Calibration Value
Check if a label-less calibration has been performed on your printer. If not, the
value is 0000.
12. Max Label Height
The max label length you can print at a time. For 200 dpi models, it is 100 inches;
for 300 dpi models, it is 50 inches.
13. Print Width
The print width in dots.
14. Lab Len (Top to Top)
For non-continues media, it is the length between the tops of two labels. You can
also use the SZPL command ^LL to define it. By default, it is 10 mm.
15. Speed
The speed of printing. The unit is inch per second (ips).
16. ABS. Darkness
The current darkness. You can use the SZPL command ~SD to define it.
17. Trim. Darkness
The adjustment of the current darkness. You can use the SZPL command ^MD to
define it.
32
Self-Test and Dump
mode
WS4-DT-r01-30-12-16TM