SATO WS408DT Technical Manual page 56

4 SATO WS4 Printer Utility
Property Name
Reprint After Error
Print Darkness
Print Speed
Stop Position for
Cutter
Stop Position for
Dispenser
Tear Off Wait Time
Zero Slash
Unit(Label)
Width
Height
Unit (Position
Adjustment)
Description
ON (Power on and Head close)
automatically calibrates media using a media sensor after
power on and every time you close the print module when
the printer is turned on.
OFF You need to manually calibrate media using a media
sensor as you change the media, or your printer won't
work properly.
Enable Your printer when caused by the error condition.
The label is reprinted as soon as the error condition is
corrected.
Disable Disable the reprint after error.
Adjust the darkness relative to the current darkness
setting. The range is +1~ +5, and the value is adjustable in
increments of 1.
±
Determine the media speed during printing. The range is
+2 ~ +6, and the value is adjustable in increments of
Blank Printer does not install cutter module.
Head Position Stop the paper forward on the head
position.
Cutter Position Stop the paper forward on the cutter
position.
Blank Printer does not install dispenser module.
Head Position Stop the paper forward on the head
position.
Dispense Position Stop the paper forward on the
dispenser position.
Your printer moves the paper forward in a predefined time
after printing, and pulls the paper back in a predefined
length once the printing begins again.
Display a zero with or without a slash through it.
mm Change the unit of label to millimeter.
inch Change the unit of label to inch.
Set the print width.
Set the length of the label when using continuous media.
mm Change the unit of Position Adjustment to
millimeter.
52
Work with SATO WS4 Printer Utility
Your printer
1 ips.
±