SATO WS408DT Technical Manual page 33

3 System Mode
9. SSID
Short for service set identifier. It is the name of a wireless local area network.
10. Mode
It determines how you connect your printer to a network.
Infrastructure: If you connect through an access point, select this.
Ad hoc: if you connect through a device which has connected to a network, select
this. In Ad hoc mode, you can only use Open authentication.
11. Country Code
The country or region.
12. Channel
The Wireless LAN channel.
13. Network authentication
It allows any device to authenticate to an access point (AP) and gain access to a
network.
14. WEP
ON: Encrypt data to WEP encryption. OFF: WEP encryption off.
If your printer has a Bluetooth module, your SBPL configuration label will contain
the following entries:
1. BT Device
The Bluetooth device name of your printer.
2. BT PIN
The Bluetooth passkey of your printer.
3. BT MAC Address
The Bluetooth MAC address of your printer.
4. BT MAC Address Barcode
The barcode of the Bluetooth MAC address of your printer.
30
Self-Test and Dump
mode
WS4-DT-r01-30-12-16TM