SATO WS408DT Technical Manual page 36

3 System Mode
18. Print Method
It is direct thermal printing.
19. Print Length
The total print length.
20. Cut Count
It counts the times the cutter cuts.
21. RS232 Protocol
It lists RS-232C settings in the following order: baud rate, data length, parity check,
stop bit and flow control.
22-24. Control Character
The control character your printer is using.
25. Code Page
The character set table.
26. Media
The media type in use.
27. Reprint After Error
When it is enabled, your printer reprints the label after the error fixed if it is
printed incorrectly due to the error.
28. Backfeed Enabled/Disabled
Enable or disable backfeed during the printing process. When it is enabled, your
printer moves the paper forward in a predefined length 1 second after printing,
and pulls the paper back in a predefined length once the printing begins again.
When it is disabled, your printer won't move the paper at all.
29. Cutter Enabled/Disabled
Enable or disable the cutter during the printing process.
30. Dispenser Enabled/Disabled
Enable or disable the dispenser during the printing process.
31. Cutter/Dispenser Offset
Move the cutting line or the peeling position forward or backward. The value in
the angle brackets is the offset unit.
32. IP Address
The static IP address of your printer. The default value is "192.168.1.1."
33. Subnet Mask
The manually specified subnet mask of your printer. The default value is
"255.255.255.0."
34. Gateway
The manually specified gateway of your printer. The default value is "0.0.0.0."
35. MAC Address
33
Self-Test and Dump
mode
WS4-DT-r01-30-12-16TM