Printing Via The Wireless Lan Interface - SATO MB200i Operator's Manual

Operation and Configuration

Printing via the Wireless LAN Interface

To print using the Wireless LAN interface, it must be
properly configured. The next step is to configure the
printer to share the same network settings to
establish communication.
1) Check the DIP Switches:
The printer's DIP switches are factory set for WLAN
operation. Ensure dipswitch 1 is OFF and dipswitch 2 is ON.
Refer to the full DIP-Switch table in the next chapter, should
additional dipswitches require setting.
2) Setup a connection to the Wireless Network
To ensure the printer is configured with the proper IP
address, subnet mask, gateway, SSID, Channel,
WLAN mode and security settings; refer to your MIS
personnel for details of your existing wireless network
settings. The SATO-certified System Integrator/dealer
can assist with network setup and provision of
necessary software tools.
Note
When printing with the WLAN interface, the usable
range between the printer and the host may vary
depending on the usage environment and the
capabilities of the connected devices.
For proper dipswitch configuration, refer to chapter 4.
3-5