2
Accessories Installation
2.4 Bluetooth Module
The Bluetooth module provides Bluetooth connectivity for your printer.
To install a Bluetooth module:
Step 1. Dismantle your printer
This part describes how to remove the base and the middle frame.
1. Open the top cover.
2. Loosen and remove two screws on each side of the tear bar.
3. Remove the tear bar from your printer.
4. Turn over your printer.
5. Loosen and remove four screws from the base.
6. Lift the base and unplug all the cables.
7. Remove the base and the middle frame.
Step 2. Secure the Bluetooth card and connect it to the main board
This part describes how to thread the Bluetooth card cable and connect it to the
main board.
1. Plug the Bluetooth cable (white connector) to the port on the Bluetooth card.
2. On the right side of your printer, find two screw holes under the top cover
switch, align the two holes on the Bluetooth card with them and secure the
card with two screws.
17
Bluetooth Module
WS4-DT-r01-30-12-16TM