Dispenser - SATO WS408DT Technical Manual

2 Accessories Installation

2.2 Dispenser

A dispenser automatically removes the liner from the printed label. The dispenser
sensor detects if a peeled label is taken away.
To install a dispenser:
Step 1. Remove the base and the middle frame
This part describes how to dismantle your printer.
1. Open the top cover.
2. Loosen and remove two screws on each side of the tear bar.
3. Remove the tear bar from your printer.
4. Turn over your printer.
5. Loosen and remove four screws from the base.
6. Lift the base and unplug all the cables.
7. Remove the base and the middle frame.
8. Turn over your printer.
Step 2. Connect the dispenser to the main board
This part describes how to thread the dispenser cable and connect it to the main
board.
10
Dispenser
WS4-DT-r01-30-12-16TM