SATO WS408DT Technical Manual page 57

4 SATO WS4 Printer Utility
Property Name
Horizontal Offset
Vertical Offset
Continuous Offset
Tear Off Offset
Cutter/Dispenser
Offset
Status
STX Code
ETX Code
ESC Code
ENQ Code
CAN Code
NULL Code
Offline Code
Description
Inch Change the unit of Position Adjustment to inch.
dots Change the unit of Position Adjustment to dots.
Move the print position horizontally. The positive number
is left, and the negative number is right.
Move the print position vertically. The positive number is
forward, and the negative number is backward.
Adjust the continuous offset at which the continues label is
cut.
Adjust the rest position of the media after a label is
printed, which changes the position at which the label is
torn or cut.
Adjust the cutter/dispenser offset position at which the
label is peel or cut.
This is communication protocol for SBPL. Status 3 is Enq
response and Status 4 is for the communication via driver.
When you use non-standard code, you can set the code in
this section.
When you use non-standard code, you can set the code in
this section.
When you use non-standard code, you can set the code in
this section.
When you use non-standard code, you can set the code in
this section.
When you use non-standard code, you can set the code in
this section.
When you use non-standard code, you can set the code in
this section.
When you use non-standard code, you can set the code in
this section.
53
Work with SATO WS4 Printer Utility