2
Accessories Installation
2.3 Wireless LAN Module
The Wireless LAN module provides Wireless LAN connectivity for your printer.
To install a Wireless LAN module:
Step 1. Remove the base and the middle frame
This part describes how to dismantle your printer.
1. Open the top cover.
2. Loosen and remove two screws on each side of the tear bar.
3. Remove the tear bar from your printer.
4. Turn over your printer.
5. Loosen and remove four screws from the base.
6. Lift the base and unplug all the cables.
7. Remove the base and the middle frame.
Step 2. Secure the Wireless LAN card and connect it to the main
board
This part describes how to thread the Wireless LAN card cable and connect it to
the main board.
1. Pull out the reflective sensor cable from the hole.
2. Plug the reflective sensor cable to the Reflective Sensor port of the Wireless
LAN card.
13
Wireless LAN Module
WS4-DT-r01-30-12-16TM