Accessories Installation; Cutter - SATO WS408DT Technical Manual

2 Accessories Installation

2 Accessories Installation
This chapter describes how to install accessories on your printer.

2.1 Cutter

A cutter is used to cut the label after it is printed out. Full cutter cuts a label off
from a media roll.
To install a full cutter:
Step 1. Remove the base and the middle frame
This part describes how to dismantle your printer.
1. Open the top cover.
2. Loosen and remove two screws on each side of the tear bar.
3. Remove the tear bar from your printer.
4. Turn over your printer.
5. Loosen and remove four screws from the base.
7
Cutter
WS4-DT-r01-30-12-16TM