SATO WS408DT Technical Manual page 15

2 Accessories Installation
4. Close the dispenser and thread the cable into the lower square hole.
5. Turn over your printer.
6. Reinstall the middle frame.
7. Plug the dispenser connector to J14, which is the red port located to the right
of the main board.
8. Plug all other cables back into the main board.
9. Reinstall the base and the secure it with four screws.
10. Turn over your printer.
Step 3. Test the dispenser
This part describes how to use the dispenser to peel the liner.
1. Open the dispenser.
2. Press the holder lock on the Media Roll Holders to slide them outward and
place the media roll between the holders. Make sure the print side is up and
the media roll is clamped tightly by the holders.
3. Pull the media until it reaches out of your printer. Thread the media under the
media guides.
4. Remove 1-3 labels from the liner at the start of the media.
5. Thread the liner under the plate (beside the platen roller) and the dispenser,
until the first label touches the platen roller.
6. Close the dispenser and close the top cover.
7. Send a print job or press the FEED button to test if the dispenser works.
12
Dispenser
WS4-DT-r01-30-12-16TM