Hydraulic Lift With Electronic Control - New Holland T4.75F Operator's Manual

Hydraulic lift with electronic control

WARNING
Crushing hazard!
The lifting systems must be operated by qualified personnel who are aware of the correct procedures
to follow. Make sure all lifting equipment is in good condition, and all hooks are equipped with safety
latches.
Failure to comply could result in death or serious injury.
The functions of the front lift are controlled by the same ECU as the rear lift.
For reasons of safety, the front lift controls are disabled when the tractor is started.
The disabled status is signalled by the indicator light
Enabling controls
To enable the controls, proceed as follows:
• With the engine running, check that the alternator
charging light is OFF;
• Set the switch (1) first to the raising position (B) and
then to the lowering position (A);
• Turn the work position potentiometer (2) clockwise,
then anticlockwise until the indicator
NOTE: Should a fault occur on the lift after malfunction-
ing of the sensors/actuators, the control unit will send a
signal to the indicator
identifying the fault code and the corresponding problem.
6 - WORKING OPERATIONS
goes out.
. The type of flash enables
on the instrument cluster coming on.
6-27
1
MOIL13TR00953AA
2
MOIL13TR00954AA
W0256A