New Holland T4.75F Operator's Manual page 211

4. Press and release the arrow (1) fig. 4 or the push−but-
ton (2) LO fig. 5. The display on the right will show
a cursor shortly followed by the letter corresponding to
the clutch involved in the setting with a three−digit num-
ber that increases
5. When the display shows the letter corresponding to the
clutch being calibrated, press and hold down the arrow
(2) fig. 4 or the push−button (2) LO fig. 5.
In this phase the calibration phase begins and the dis-
play shows a numerical value in mA that progressively
increases. When the numerical progression stops, the
value of the calibration current blinks.
6. Release the arrow (2) fig. 4 or the push button (2) LO
fig. 5. Press the arrow (1) fig. 4 or HI (3) fig. 5 to
display the next clutch to calibrate, for example: B
NOTICE: Transmission output rpm, clutch pedal position, shuttle lever position, and gear/range lever position are
constantly monitored. Calibration cannot proceed unless the tractor is stopped, shuttle lever in gear, gear and range
levers not in neutral, and the clutch pedal is up. If while in calibration an anomalous condition is detected it is shown on
the display with its error code via the alarm lamp, if the error is related to the calibration, then its 'U' code is displayed
on the LCD. See the list of related codes on the next page.
NOTE: If the letter related to the clutch does not appear and the cursor keeps on scrolling at the bottom of the display,
it means that the engine speed is not constant.
7 - MAINTENANCE
7-57
4
MOIL13TR00710AA
5
MOIL13TR00711AA
6
MOIL13TR00712AA