Hydraulic Lift Control Pump Removal And Refitting With Pump Removed - New Holland TD60D Repair Manual

SECTION 35 − HYDRAULIC SYSTEM − CHAPTER 1
24622
1. Front cover.
2. Cover seals.
3. Pump body.
4. Gear support.
5. Driven and driving gear shafts.
6. Gear support.
7. Bushing.
8. Control side cover.
9. Driving shaft seal.
10. Spacer.
Removal − refitting with pump removed
(Op. 35 0101 10)
Proceed as follows:
1. Remove the cover fastening nuts (20), then the
bolts (15) and the safety washers.
2. Remove the nut (14) that fastens the sleeve to the
pump driving shaft and the safety washer.
3. Remove the front cover (8), the snap ring (12)
and the seals (9 and 11).
4. Mark parts 3, 4, 5 and 6 to enable them to be
remounted in the same position if they are in
good condition.
5. Remove the supports (4 and 6) and the gears (5)
from the rear cover (8) and the pump body (3).
Hydraulic lift control pump components
11. Driving shaft seal.
12. Snap ring.
13. Safety washer.
14. Nut.
15. Bolt.
16. Washer.
17. Key.
18. Bushing.
19. Safety washer.
20. Nut.
HYDRAULIC LIFT CONTROL OIL PUMP
41
88
603.54.471.00 − 11 − 2004